HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 358

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_DEVICE_RESOURCE_RAN_OUT ) Too many controllers were presented to the cluster [chars]. Explanation The configuration is not valid. Too many devices have been presented to the cluster or node. Recommended Action 1. Remove unwanted devices from the Fibre Channel network fabric. 2. Start a cluster discovery operation to find devices. 3. List all connected managed disks. Check with the customer that the configuration is as expected. Mark the error you have just repaired fixed. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_IO_ERP ) Error Recovery Procedure occurred [chars]. Explanation A managed disk error recovery procedure (ERP) has occurred. This error has been reported because a large number of disk error recovery procedures have been performed by the disk controller. The problem is probably caused by a failure of some other component on the SAN. Recommended Action 1. View the error log entry and determine the managed disk that was being accessed when the problem was detected. 2. Perform the disk controller problem determination and repair procedures for the managed disk determined in Step 1. 3. Perform Fibre Channel switch problem determination and repair procedures for the Fibre Channel switches containing the node, and connected to the disk controller that is managing the managed disk, and any Fibre Channel switches in the Fibre Channel path between those switches. 4. Mark resolved errors from Steps 2 and 3 as fixed. 5. Take an error log dump if no switch or disk controller failures were resolved in Steps 2 and 3. Call your customer support representative. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_IO_ERROR ) Managed Disk I/O error [chars]. Explanation A managed disk or managed disk controller port has been excluded because of excessive errors or unusual behavior. Recommended Action 1. Repair the enclosure or disk controller. 2. Check the managed disk status. If any managed disks show a status of online, mark the error you have just repaired as fixed. If any managed disks show a status of excluded, include the managed disks and then mark the error as fixed. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec] SS_EID_VL_ER_IO_THRESHOLD ) Managed Disk error count threshold exceeded [chars]. Explanation A managed disk or managed disk controller port has been excluded because of excessive errors or unusual behavior. Recommended Action 1. Repair the enclosure or disk controller. 2. Check the managed disk status. If any managed disks show a status of online, mark the error you have just repaired as fixed. If any managed disks show a status of excluded, include the managed disks and then mark the error as fixed. 2-322 Cisco MDS 9000 Family System Messages Reference OL-15956-01