HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 293
PORT_CHANNEL Messages, PORT_CHANNEL-1, show port-channel consistency
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 293 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] PORT_CHANNEL Messages This section contains the PortChannel (PORT_CHANNEL) messages. PORT_CHANNEL-1 Error Message PORT_CHANNEL-1-LC_CFG_FAILURE: configuring module [dec] failed [[chars]]. Explanation Module configuration failed. Recommended Action The module is automatically reset. If the problem persists, contact your customer support representative. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT_CHANNEL-1-MALLOC_FAILED: cannot allocate memory (size [dec]). Explanation There is not enough memory. Recommended Action Check if the system is low on memory and reset the switch if necessary. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT_CHANNEL-1-MAP_PARAM_FAILURE: mapping parameter failed for [chars] [[chars]]. Explanation Parameter mapping failed. Recommended Action The specified service is misbehaving. Check its status. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT_CHANNEL-1-MCAST_SEND_FAILURE: failed to send multicast [chars]: [chars]. Explanation Failed to send a multicast message to all modules, usually because some module went down. Recommended Action Enter the show port-channel consistency CLI command or use a similar Fabric Manager/Device Manager procedure to check consistency. Introduced Cisco MDS SAN-OS Release 1.2(2a). OL-15956-01 Cisco MDS 9000 Family System Messages Reference 2-257