HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 205

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message IVR-2-DEVICE_VSAN_REWRITE_FAILURE: Failure while programming VSAN rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able to communicate with its peer devices. Explanation Device failed to program the VSAN rewrite entries, probably because the hardware ran out of VSAN rewrite entries. This can happen if there are too many devices in an inter-VSAN zone or too many local VSANs in the VSAN topology. Recommended Action Reduce the number of domains involved in IVR by moving the members of the active IVR zone set to fewer switches. Also, reduce the number of redundant transit VSANs, if any. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message IVR-2-DOMAIN_DISALLOWED_IN_INTEROP: Device with port WWN [chars] and FCID [chars] may not be able to participate in Inter-VSAN zone since domain [dec] is disallowed in the interop mode for VSAN [dec]. Explanation VSAN interop modes place restrictions on what domain ranges are allowed. This domain is out of the range allowed for this interop mode. Refer to the Cisco MDS 9000 Family CLI Configuration Guide or Cisco MDS 9000 Family Fabric Manager Configuration Guide for details on the domain range limitations. Recommended Action Change the domain of the switch to which this IVR zone member is connected so that it is within the allowed domain list for the interop mode. The domain identifier can be statically assigned using the fcdomain interface. You can also configure a range of domains allowed in a VSAN using the fcdomain's allowed-domains interface. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message IVR-2-DOMAIN_UNAVAILABLE: Device with port WWN [chars] and FCID [chars] may not be able to participate in Inter-VSAN zone since domain [dec] is already assigned in VSAN [dec]. Explanation Device with the port WWN and FC ID shown in the error message may not be able to participate in the inter-VSAN zone because the domain shown is already assigned in a VSAN. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message IVR-2-INTEROP_MODE_2_OR_3_BF_FAILED: [chars] VSAN [dec] Virtual Domain [chars]. Explanation Build fabric failed in VSAN [dec]. The build fabric was initiated to remove an unused virtual domain from the fcdomain list in that VSAN. The virtual domain still remains in the fcdomain list and hence it would not be available in that VSAN for assignment. Recommended Action Perform a manual build fabric using fcdomain's interface if you would like to remove the unused virtual domain(s) from the fcdomain list. Introduced Cisco MDS SAN-OS Release 1.3(4a). OL-15956-01 Cisco MDS 9000 Family System Messages Reference 2-169