HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 350

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message SPAN-5-STATELESS_RESTART_ON_ACTIVE: Span is restarting as Span on active sup was restarted stateless. Explanation Because of an unrecoverable error, the switched port analyzer (SPAN) on the active supervisor was restarted stateless. So, the standby SPAN restarts to get in sync with the stateless SPAN on the active supervisor. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.3(1). SPAN-6 Error Message SPAN-6-SESSION_DOWN: Session [dec] is inactive ([chars]). Explanation Session is inactive now. Traffic for this session is no longer spanned. Recommended Action Check the reason for session inactivity by entering the show span session CLI command or by using a similar Fabric Manager/Device Manager procedure. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message SPAN-6-SESSION_UP: Session [dec] is active, destination SD port [chars]. Explanation Session is active now. You can monitor spanned traffic at the destination SD port. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message SPAN-6-STATELESS_SWITCHOVER: Span is starting stateless after switchover. Explanation Active sessions are not preserved across switchover. The switched port analyzer (SPAN) is starting stateless and the configuration will be reapplied to get back the active configuration. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). SPI Messages This section contains the SPI messages. 2-314 Cisco MDS 9000 Family System Messages Reference OL-15956-01