HP Designjet 350c HP Designjet 330 and 350C Plotters - Users Guide - Page 105
To change the serial interface settings, To change the graphics language setting for less, common
View all HP Designjet 350c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Parallel Serial Reconfiguring your plotter Serial interface / graphics language To change the serial interface settings With a parallel interface, no front-panel configuration is necessary. With a serial interface, you should have checked the configuration (baud rate and parity) when installing the plotter and, if necessary, changed it. However, you may need to reconfigure it: when you connect a new computer to the plotter when you output to the plotter from a new application if you experience problems with distorted or unintelligible plots. To change the serial interface settings, use the setup sheet, as explained from page 1-19. To change the graphics language setting for less common applications Your software application communicates with the plotter by a graphics language. The HP DesignJets 330 and 350C support HP-GL (7586B), HP-GL/2 and HP RTL. The plotter's default setting, HP-GL (7586B), is designed to work successfully with most applications. However, it's possible that with some older or less common applications, you may need to change this setting to HP-GL/2. To change the graphics language setting, use the Setup Sheet, as explained from page 1-19. Graphics language 7586, HP-GL/2 HP-GL/2 Comments With this setting, most drivers will automatically switch the plotter's language to the one appropriate to the data being sent, including HP-GL/2 and RTL. Try this setting if you are sending an HP-GL/2 file to the plotter and: D if you have experienced plot position problems. D if you have experienced timing problems. 6-3 RECONFIG- 6 URATION