HP Designjet 350c HP Designjet 330 and 350C Plotters - Users Guide - Page 61

Working with media Loading roll media To feed roll media into the plotter 1 If the leading edge of the roll is uneven, you may find it easier to load if you trim it now, for example with scissors. However, once it is successfully loaded, you can use the plotter's built-in cutter to trim it, as explained in step 10 below. 2 Wind the media around the upper roller and hold it ready to load into the plotter. Hold the media by its edges, about 18 cm (7 in) from the top. MEDIA 2 1923a 1928 Media path (view from right) Don't hold the media right at the top, as you would have to adjust your grip as you push it into the plotter, and this would probably make you misalign it. Don't place your hands flat on the surface of the media (as is normal when loading media into some old pen plotters), as this would make step 5 very difficult for you. 3 Align the right-hand side of the media with the line of holes on the plotter. 2-21