HP Designjet 350c HP Designjet 330 and 350C Plotters - Users Guide - Page 23
Switch on the plotter, by pushing the power switch. - troubleshooting
View all HP Designjet 350c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
SETUP 1 Setting up your plotter Task 4: Switch on WARNING Task 4: Switch on Be sure that the power cord supplied with your plotter matches your ac power connection requirements. Use only three-wire (earth-grounded) power cords with this plotter. 1 Make sure that the power switch on the front of the plotter is in the OFF position (extended). 2 Plug the power cord into the socket at the back of the plotter, and then into your power outlet. 1740a 3 Switch on the plotter, by pushing the power switch. on off 1741 4 If there is no sound, nor any light on the front panel, you may have a power problem. For troubleshooting information, see chapter 9. 1-9
1–9
Task 4: Switch on
Be sure that the power cord supplied with your plotter matches your ac power
connection requirements.
Use only three-wire (earth-grounded) power cords
with this plotter.
1
Make sure that the power switch on the front of the plotter is in the OFF position
(extended).
2
Plug the power cord into the socket at the back of the plotter, and then into
your power outlet.
1740a
3
Switch on the plotter, by pushing the power switch.
on
off
1741
4
If there is no sound, nor any light on the front panel, you may have a power
problem.
For troubleshooting information, see chapter 9.
SETUP
1
Setting up your plotter
Task 4: Switch on
WARNING