HP Designjet 350c HP Designjet 330 and 350C Plotters - Users Guide - Page 21

SETUP 1 Setting up your plotter Task 2: (Optional) Install a memory expansion module CAUTION Before handling a memory module, either put on a grounding wrist strap and attach the end to the metal chassis of the plotter, or touch the outer metal surface of the plotter with your hand. Otherwise, static electricity from your body could damage the memory module. 3 Take the memory module out of its bag, holding the module only by the edges. 4 With the module's small notch on the left and the metallic edge away from you, load the module into the slot nearest to you. (The other slot is not for memory modules.) To do this, first hold the module at an angle, and then gradually push it back until it clicks into place vertically. Notch 2 Slot nearest to you 1 Push until it clicks into place 1738a 5 Replace the cover plat and screws. 1-7