HP rp5400 User Guide - HP rp5400 Family of Servers - Page 172
HotSwap Power Supply Removal
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Removing and Replacing Components Individual Component Remove/Replace Instructions HotSwap Power Supply Removal Up to three power supplies (0 through 2), located across the bottom front of the server, can be installed in the server without removing power. To remove a power supply from the server, perform the following step: 1. Remove the T-15 mounting screw located to the right of the handle near the top of the power supply. CAUTION Be careful when pulling the power supply out of the server. It is heavier than it appears. 2. Grasp the handle and pull the power supply out of the server. The following graphic shows a front and rear view of a HotSwap Power Supply. 158 Chapter 7
Chapter 7
Removing and Replacing Components
Individual Component Remove/Replace Instructions
158
HotSwap Power Supply Removal
Up to three power supplies (0 through 2), located across the bottom front of the server, can be installed in the
server without removing power.
To remove a power supply from the server, perform the following step:
1. Remove the T-15 mounting screw located to the right of the handle near the top of the power supply.
CAUTION
Be careful when pulling the power supply out of the server. It is heavier than it appears.
2. Grasp the handle and pull the power supply out of the server.
The following graphic shows a front and rear view of a HotSwap Power Supply.