HP rp5400 User Guide - HP rp5400 Family of Servers - Page 186
PCI I/O Card Removal, will require system reconfiguration and could cause boot failure.
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
Removing and Replacing Components Individual Component Remove/Replace Instructions PCI I/O Card Removal The side service bay contains card slots for ten PCI I/O cards (slots 3 through 12) and two Core I/O cards (slots 1 and 2). Perform the following tasks prior to removing PCI I/O cards: • Power down the server. • Detach all power cords from the server. To remove a PCI I/O card from the server, perform the following steps: NOTE Record the location of all PCI cards as they are removed. Replacing them in a diffferent location will require system reconfiguration and could cause boot failure. 1. Disconnect the I/O cable attached to the I/O card at the rear PCI bulkhead. 2. Disconnect any ribbon cable connectors attached to the I/O card in the side service bay. 3. Grasp the edge of the I/O card and pull it out of the server. The following graphic shows an I/O card being removed. 172 Chapter 7