HP rp5400 User Guide - HP rp5400 Family of Servers - Page 187
PCI I/O Card Replacement
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
Removing and Replacing Components Individual Component Remove/Replace Instructions PCI I/O Card Replacement The side service bay contains card slots for 10 PCI I/O cards (slots 3 through 12) and 2 Core I/O cards (slots 1 and 2). Prior to replacing PCI cards, perform the steps listed below: • Power down the server. • Detach all power cords from the server. To replace a Core or PCI I/O card, perform the following steps: 1. Locate the I/O card guide (item 1) on the outside of the Fan Assembly Housing. Orient the I/O card into its guide slot and push it into the server until the card connector seats in the I/O Backplane card connector. NOTE Each I/O card guide contains two slots. The top slot is aligned with the I/O Backplane card connector. 1 2. Connect the I/O cable attached to the I/O card at the rear PCI bulkhead. 3. Connect any ribbon cable connectors attached to the I/O card in the side service bay. Chapter 7 173