HP rp5400 User Guide - HP rp5400 Family of Servers - Page 70
HP 700 Series System Console Configuration, HP700 VT-100 Mode Configuration
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Cable Connections Configure System Consoles HP 700 Series System Console Configuration The following describes the steps required to configure the HP 700 series terminal for VT-100 mode for operation with an rp54xx server. Although any terminal capable of operating in VT-100 mode can be used, the HP700 series terminal is used here as an example because it is fairly common and it's configuration is typical of many terminals currently in use. HP700 VT-100 Mode Configuration The following procedure outlines the steps to configure the HP700 series terminal for VT100 operation. NOTE You may use either the arrow keys or the tab key to move between the setting options on the screen. 1. Press [config keys] function key. [f8] 2. Press [terminal config] function key. [f5] 3. Move to Terminal ID and enter "vt100". 4. Move to Set TermMode and, using the [Prev] and [Next] keys, select "EM100". 5. Press the [config keys] function key. [f8] 6. Press the [ansi config] function key. [f6] 7. Move to "multipage" and, using the [Prev] and [Next] keys, select "yes". (Enables screen scrolling). 8. Move to Backspace Del and, using the [Prev] and [Next] keys, select "Backspace/Del". 9. Move to EM100 ID and, using the [Prev] and [Next] keys, select "EM100". Configure the Asynchronous Values of the GSP After the ASCII console has been configured and physical connections made, make any necessary changes to the asynchronous values of the GSP. 1. Access the GSP with the ctrl+b entry. The GSP will respond with a GSP> prompt. 2. At the GSP prompt, enter the Configure Asynchronous (ca) command: The ca command will start a series of prompts. Respond to each prompt with the appropriate information. Example 4-1 CA command Leaving Console Mode - you may lose write access. When Console Mode returns, type ^Ecf to get console write access. GSP Host Name: fesrhapgsp GSP> ca CA This command allows you to modify the local and remote modem serial portconfigurations. Current configuration settings: Local Console Serial Port bit rate: 9600 bits/s Local Console Serial Port Flow Control: Software 56 Chapter 4