HP rp5400 User Guide - HP rp5400 Family of Servers - Page 48
Installing a PCI Card, Step 1., rp5400, rp5430/rp5470, Slot Type, Turbo, Twin Turbo
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Installing Additional Components Installing Peripheral Component Interconnect (PCI) Cards Installing a PCI Card Follow these procedures to install a PCI card. Step 1. Power down and unplug the rp54xx server. NOTE DC voltages are present when the server is connected to AC power. Do not attempt to install or service: CPUs, Memory, PSMs, the Platform Monitor or PCI I/O cards installed in non-Turbo slots (1-6) while DC voltage is present. Failure to observe this warning may result in damage to the server. Step 2. Make the right side of the server accessible for service. Step 3. Using a Torx 15 screwdriver, loosen the captive screws on the right side panel. This panel has a label which shows which PCI I/O slots are available and the corresponding paths. The PCI I/O slot paths for rp5400, rp5450, and rp5470 are shown below. rp5400 rp5450 rp5430/rp5470 Slot Slot Type Path Slot/Type Path Slot Type Path 12 Turbo 0/4/0 Turbo 0/4/0 Twin Turbo 11 Turbo 0/7/0 Turbo 0/7/0 Twin Turbo 10 Turbo 0/3/0 Turbo 0/3/0 Turbo 9 Turbo 0/6/0 Turbo 0/6/0 Turbo 8 Turbo 0/2/0 Turbo 0/2/0 Turbo 7 Not Available Turbo 0/5/0 Turboa 6 Not Available Shared 0/1/0 Turboa 5 Not Available Shared 0/1/1 Turboa 4 Not Available Shared 0/1/2 Shareda 3 Not Availableb Shared 0/1/3 Shared 2 GSP GSP GSP 1 LAN/SCSI LAN/SCSI LAN/SCSI a. Slot is NOT AVAILABLE for rp5430. b. Slot 3 becomes available with server firmware versions later than 40.48. 0/10/0 0/12/0 0/8/0 0/9/0 0/3/0 0/1/0 0/5/0 0/2/0 0/4/0 0/4/2 Step 4. Remove the PCI slot cover from the slot that will receive the PCI card. To remove the PCI slot cover, slide the PCI slot cover away from the server. 34 Chapter 3