Honeywell HRSD40F250 User Guide - Page 151
Troubleshooting E
View all Honeywell HRSD40F250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Troubleshooting E Troubleshooting Problem No Power No Live Video No Live Video on the VGA Monitor DVR has stopped recording The icon displays, however, the DVR is not recording. Possible Solution • Check power cord connections • Confirm that there is power at the outlet • Check camera video cable and connections • Check monitor video cable and connections • Confirm that the camera has power • Check camera lens settings • Check CVBS/VGA switch settings If the DVR does not detect a VGA monitor automatically, press and hold the PANIC button ( )on the front panel or remote control for 5 seconds or longer to switch the video output from Video out to VGA out. If the hard disk drive is full, you need to either delete video or set the DVR to the Overwrite Mode. When the DVR is in the Pre-Event recording mode, the yellow and display when there is no event, and the DVR is not recording. The red and display when any event occurs and the DVR starts recording. Document 800-03097 Rev C 151 03/09