Honeywell HRSD40F250 User Guide - Page 86
Setting the Minimum Number of Motion Detection Blocks, Viewing How the DVR Reacts to Motion
View all Honeywell HRSD40F250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
HRSD40F DVR User Guide Table 3-11 Motion Detection Zone Setup Screen Options Option Clear All OK Cancel Function Deactivates all blocks so they will not detect motion. Accepts changes and closes Zone setup. Exits Zone setup without saving changes. 3. Save your changes by highlighting OK and pressing the screen without saving the changes. . Select Cancel to exit Setting the Minimum Number of Motion Detection Blocks You can adjust the minimum number of detection blocks that must be activated to trigger a motion alarm. Daytime and Nighttime can be set independently. Highlight a field under the Min. Blocks heading and press - Min. Blocks screen appears. . The Motion Detection Figure 3-56 Motion Detection - Min. Blocks Setup Screen For greater sensitivity, select a smaller number of blocks. A smaller number means that fewer detection blocks need to be triggered for motion detection. Viewing How the DVR Reacts to Motion Zone View allows you to observe how the DVR reacts to motion. When in the motion viewing mode, any detected motion within the zone displays in red. Highlight the box beside Zone View, and press to toggle it On and Off. Ignoring Excessive Motion You can control excessive event logging and remote notification of motions detected after the motion dwell time by adjusting the motion ignoring dwell intervals. 1. Highlight the box beside Motion Ignoring Interval and press . A drop-down menu of intervals ranging from 1 to 5 seconds or Never appears. 2. Select an interval from the drop-down menu. 86