Honeywell HRSD40F250 User Guide - Page 31
Connecting the Audio In/Out, Connecting the Power Cord, Audio In 1
View all Honeywell HRSD40F250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Installation Caution This Network Port is not designed to be connected with cables or wires that are intended for outdoor use. Connecting the Audio In/Out Your DVR can record audio from up to four sources. Connect the audio sources to Audio In 1, Audio In 2, Audio In 3, and Audio In 4 as needed using RCA jacks. Connect Audio Out to your amplifier. Figure 2-10 Audio In/Out Connectors AUDIO IN 1 AUDIO IN 2 AUDIO IN 3 AUDIOIN4 AUDIOOUT Note It is the user's responsibility to determine if local laws and regulations permit recording audio. Note The DVR does not have amplified audio output, so you will need a speaker with an amplifier. The DVR does not have a pre-amplifier for audio input, so the audio input should be from an amplified source; not directly from a microphone. Connecting the Power Cord Connect the power cord to the DVR and then to a wall outlet. Document 800-03097 Rev C 31 03/09