Kyocera ECOSYS M2035dn ECOSYS M2030dn/M2035dn/M2530dn/M2535dn Operation Guide - Page 369

Default Setting (System Menu) LDAP Security Select the communication protocol according to the type of security employed by the LDAP server. The default setting is Off. NOTE: LDAP must be set to On in Protocol Detail on page 8-151. The table below shows the available settings. Item Off SSL/TLS STARTTLS Description Do not use security employed by the LDAP server. Encryption is applied any data communication. To enable LDAP security, the LDAP port may have to be changed according to the server settings. Typically, 636* for SSL/TLS is well-known LDAP port. Encryption is applied any data communication. Typically, 389* for STARTTLS is well-known LDAP port. * You can change the port number using Command Center RX. 8 Use the procedure below to make the setting. Sys. Menu/Count.:a b 1 Report 2 Counter *3 **S*y*s*t*e*m*/*N*e*t*w*o*r*k***** [ Exit ] 1 In the Sys. Menu/Count. menu, press the  or  key to select [System/Network], and press the OK key. Login User Name: L b Login Password: A login screen will appear. Then, enter the user ID and password with administrator privileges to log in, and press [Login] (the Right Select key). [ Login ] System/Network: a b *1**N*e*t*w*o*r*k**S*e*t*t*i*n*g**** 2 I/F Block Set. 3 Security Level [ Exit ] 2 The System/Network menu appears. Network Setting: a b *5**S*e*c*u*r*e**P*r*o*t*o*c*o*l**** 6 Host Name 7 LAN Interface [ Exit ] 3 Press the  or  key to select [Network Setting]. 4 Press the OK key. The Network Setting menu appears. 8-159