Kyocera ECOSYS M2035dn ECOSYS M2030dn/M2035dn/M2530dn/M2535dn Operation Guide - Page 72

Preparation before Use 3 Enter the appropriate values to each field. SMTP POP3 Setting Description Set to send e-mail from the machine. SMTP Protocol Set SMTP protocol. Set the "SMTP (E-mail TX)" setting to [On] on the [Protocol Settings] page. SMTP Server Name Enter the host name or IP address of the SMTP server. SMTP Port Number Specify the port number to be used for SMTP. Use the SMTP default port 25. SMTP Server Timeout Set the amount of time to wait before time-out in seconds. Authentication Protocol Set whether SMTP authentication is used. To use authentication, enter the user information for authentication. SMTP Security Set SMTP security. Turn on "SMTP Security" in "SMTP (E-mail TX)" on the [Protocol Settings] page. POP before SMTP Timeout Specify the time in seconds until the connection to the POP server times outs. This can be set when [POP before SMTP] is selected in "Authentication Protocol". Connection Test Tests to confirm that the settings are correct. Domain Restriction Set whether or not domains are restricted. Click the [Domain List] and enter the domain names of addresses to be allowed or rejected. Restriction can also be specified by e-mail address. Set to receive e-mail at the machine. POP3 Protocol Set POP3 protocol. Set the "POP3 (E-mail RX)" setting to [On] on the [Protocol Settings] page. Check Interval Specify the interval for checking for incoming e-mail in minutes. Run once now Click [Receive] to connect to the POP3 server immediately and check for incoming E-mails. Domain Restriction Set whether or not domains are restricted. Click the [Domain List] and enter the domain names of addresses to be allowed or rejected. Restriction can also be specified by e-mail address. POP3 User Settings Configure the settings for POP3 user accounts and the POP3 server. You can configure up to three users. 2-34