Kyocera FS 3830N FS-3820N/3830N Operation Guide Rev-1.1 - Page 101

Operating the Storage Device 7 In this state, send the file from the computer to the printer. The file is written onto the storage device given a destination name (also referred to as a partition name) which the printer automatically assigns one after another as follows: DataS001 (first data), DataS002 (second data), DataS003 (third data)... In the example above, if the file TEST.TXT is the first data to be written onto the storage device, the destination name will be DataS001. As the printer receives data, the message display changes to Processing, then when the end of the data is received, the message display changes to Waiting. 8 Check that the message display has changed to Waiting, then press the GO key. This writes the file to the memory card and instructs the printer to automatically print out a CompactFlash card write information page as shown below. FS-3830N Page Printer WRITE INFORMATION Partition Type. Type of data written (currently only type 2 is supported). Partition Name. Name of data written. Write Partition Length. Length (size) of the data written. Others. Additional information, such as error information. When the write information page is printed, the message display returns to Ready. If the writing was not completed successfully, an error code appears on the message display. For details, see Error Messages on page 4-10. If this happens, press the GO key. The message display returns to Ready. 1-85