Kyocera FS 3830N FS-3820N/3830N Operation Guide Rev-1.1 - Page 98
RAM Disk Mode, >RAM Disk Size, Mbyte
View all Kyocera FS 3830N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Operating the Storage Device 3 The default setting is Off. Press the ENTER key. A blinking question mark (?) appears. Select On using the or key, and then press the ENTER key. RAM Disk Mode ? On 4 Press the > key to display >RAM Disk Size. >RAM Disk Size 0087 Mbyte 5 Press the ENTER key again, and change the RAM disk size using the or key. It is not possible to make a setting that exceeds total printer memory. The default value for the RAM disk is the total printer memory minus 9 MB. This parameter may be set anywhere from 0001 to 1024 depending on the available printer memory. 6 When the desired RAM disk size is displayed, press the ENTER key. 7 Press the MENU key and restart the printer. The setting will be activated after restart. 1-82
Operating the Storage Device
1-82
3
The default setting is
Off
. Press the
ENTER
key. A blinking question
mark (
?
) appears. Select
On
using the
or
key, and then press the
ENTER
key.
4
Press the
>
key to display
>RAM Disk Size
.
5
Press the
ENTER
key again, and change the RAM disk size using the
or
key. It is not possible to make a setting that exceeds total
printer memory. The default value for the RAM disk is the total
printer memory minus 9 MB. This parameter may be set anywhere
from
0001
to
1024
depending on the available printer memory.
6
When the desired RAM disk size is displayed, press the
ENTER
key.
7
Press the
MENU
key and restart the printer. The setting will be
activated after restart.
RAM Disk Mode
? On
>RAM Disk Size
0087 Mbyte