Kyocera FS 3830N FS-3820N/3830N Operation Guide Rev-1.1 - Page 94
Network Interface Parameters, Interface, Parallel, Network - set dhcp
View all Kyocera FS 3830N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Interface Network Interface Parameters This printer supports TCP/IP, NetWare and EtherTalk protocols. In addition, you can install the option network interface card in the option interface slot. Using the operator panel, you can: • Activate or deactivate TCP/IP, NetWare, and EtherTalk • Activate or deactivate DHCP • Enter IP address, subnet mask address, and default gateway address To confirm or change network card parameters, proceed as follows: 1 Press the MENU key. 2 Press the or key repeatedly until Interface > appears. One of the interface names shown below appears, indicating the current interface. Parallel (default) USB Network Serial (when a serial interface board kit is installed) Option (when a network interface card is installed) 3 Press the ENTER key. A blinking question mark (?) appears. Interface ? Parallel If the option network interface card is installed in the printer, Option will be displayed. The setting procedure is basically the same even in this case. 4 Press the or key repeatedly until Network appears. Interface ? Network 5 Press the ENTER key again. 1-78