Kyocera FS 3830N FS-3820N/3830N Operation Guide Rev-1.1 - Page 92
Serial Interface Parameters, Interface, Parallel, Serial
View all Kyocera FS 3830N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Interface Serial Interface Parameters Option This section applies to the printers having the option serial interface board kit (IB-11) installed. The baud rate, data bits, stop bits, parity, and protocol for the serial interface can be set as follows: 1 Press the MENU key. 2 Press the or key repeatedly until Interface > appears. One of the interface names shown below appears, indicating the current interface. Parallel (default) USB Network Serial (when a serial interface board kit is installed) Option (when a network interface card is installed) 3 Press the ENTER key. A blinking question mark (?) appears. Interface ? Parallel If you want to abandon the interface selection procedure, press the CANCEL key. The interface remains unchanged. 4 Press the or key repeatedly until Serial appears. Interface ? Serial 5 Press the ENTER key again. 1-76