Kyocera FS 3830N FS-3820N/3830N Operation Guide Rev-1.1 - Page 75

e-MPS Proof and Hold Deleting a Quick Copy Job All quick copy jobs are automatically deleted when the printer is turned off. If you desire to explicitly delete a stored quick copy job, proceed as follows: 1 Follow steps 1 through 8 in the above section to let the title of the job displayed. 2 When the title of the job is displayed, e.g. Report, below, press the ENTER key. The cursor below the copy count starts to blink. >Report Copies 001 3 Press the key repeatedly until Delete appears below the title. >Report Delete _ 4 Press the ENTER key. The stored quick copy job is deleted. When you print multiple copies, this mode first prints one copy so that you can proof it before continuing to print the remaining copies. Since you can proof the printouts before printing the remaining copies, wastage of paper can be reduced. The printer prints one copy and, at the same time, saves the print job on the Microdrive. You can also change the number of copies when resuming printing from the operator panel. When the printer is turned off, all stored jobs will be deleted. Printing Remaining Copies of a Proof and Hold Job Printing a Proof and Hold job on the operator panel is similar to printing a quick copy job. To print remaining copies of a job held in the printer: 1 Press the MENU key. 2 Press the or key repeatedly until e-MPS > appears. e-MPS > 3 Press the > key. 1-59