Kyocera TASKalfa 3050ci 3050ci/3550ci/4550ci/5550ci Operation Guide Rev-2.2011 - Page 211

Copying Functions OHP Backing Sheet When two or three OHP transparencies are stacked on top of each other, static electricity may make them difficult to handle. When using OHP Backing Sheet, a paper sheet is automatically inserted between each transparency, making them easier to handle. Also, the same original page can be copied to the backing sheet for multiple page copying. NOTE: For transparency film that can be used, refer to Transparencies on page Appendix-18. Never load OHP transparencies into trays or cassettes other than the multi purpose tray. When OHP Backing Sheet is set, the multi purpose tray paper type is automatically set to Transparency. If the optional document finisher is installed, you may need to specify the output destination for finished copies. 4 For further details, refer to Paper Output on page 4-13. Blank Sheet 1 2 3 1* 2* 3* Outputs a blank backing sheet after copying to a transparency. (* denotes OHP film.) Original Copied Sheet Copy 1 2 3 1* 1 2* 2 3* 3 Original Copy Follow the steps below for OHP Backing Sheet. After copying to a transparency, copies the same original image to the backing sheet paper. (* denotes OHP film.) 1 Press the Copy key. 2 Place the original. 3 Load the transparencies into the multi purpose tray. IMPORTANT: Fan through the transparencies before loading. Up to 10 transparencies can be loaded at one time. Be sure that paper of the same size and orientation as the transparencies is loaded in the cassette. 4-51