Kyocera TASKalfa 3050ci 3050ci/3550ci/4550ci/5550ci Operation Guide Rev-2.2011 - Page 375
Calibration Cycle, Default Setting System Menu, Registration, Remaining: xx seconds
View all Kyocera TASKalfa 3050ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 375 highlights
Default Setting (System Menu) 4 Find the location on each chart where 2 lines most closely match. If this is the 0 position, registration for that color is not required. For the illustration, B is the appropriate value. From charts V-1 to V-5, read only the values from V-3 (center). 5 Press [Next] of Registration. 6 Press [Change] for the chart to be corrected. 7 Press [+] or [-] to enter the values read from the chart and press [OK]. Press [+] to increase the value from 0 to 9. To decrease, press [-]. By pressing [-], the value changes from 0 to alphabetic letters, going from A to I. To move in the reverse direction, press [+]. You cannot use the numeric keys to enter these values. 8 Repeat steps 6 and 7 to enter the registration values for each chart. 9 Press [Start] after all values have been entered. Color registration begins. 10 Press [OK] after color registration is complete. Calibration Cycle After Auto Clear has been activated, or during printing or while processing Color Registration, Calibration... Remaining: xx seconds may be displayed. While this message is displayed, the machine makes adjustments to maintain image quality. Wait until the message disappears. 9 NOTE: If [Custom] appears in the setting items, the setting cannot be changed. Set the calibration cycle here. The setting items are as follows. Auto Short Item Standard Long Description Automatically sets the cycle for calibration. Sets a short calibration cycle and increases the number of times performed, with priority to image quality. Sets a standard calibration cycle, compromising between image quality and downtime for processing. Sets a long calibration cycle and decreases the number of times performed, to ensure minimal downtime. 1 Press the System Menu key. 2 Press [ ], [Adjustment/Maintenance], [ ] and then [Change] of Calibration Cycle. 3 Select [Auto], [Short], [Standard] or [Long]. 4 Press [OK]. 9-71