Lexmark Optra C Service Manual - Page 129
Removal Procedures, Attraction Roller Drive Assembly
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
5045-001 Removal Procedures The removals in this section are arranged in alphabetical order. To install parts, reverse the removal procedure, giving attention to any special conditions listed. When reinstalling the drive gear solenoid assembly removed in step 9, rotate the main drive motor (M2) counterclockwise after installing the 4 screws. This ensures that all the gears latch up. Rotate the motor until all the gears latch up and the motor turns freely. Attraction Roller Drive Assembly For cover removals, see "Cover Removals" on page 4-8. 1. Remove the top cover 2. Remove the left side cover. 3. Remove the rear cover. 4. Remove the EMC shield from the rear of the machine. 5. Open the multipurpose paper pickup door. 6. Release the two green cassette latches and slide the tray out as far as possible. 7. Remove the connector cover (Asm 8-24) and disconnect the connector. 8. Remove the LVPS. 9. Disconnect connector (J2014) from the mechanical controller PCB. 10. Remove the four mounting screws to the drive gear solenoid assembly and remove the assembly. Disconnect the remaining 2 pin connector from the frame. 11. Remove the two screws from the attraction roller drive assembly and remove the assembly. Repair Information 4-3