Lexmark Optra C Service Manual - Page 155
Fuser Assembly, Repair Information 4-29
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
5045-001 Fuser Assembly See Assembly 32-1. 1. Open the multipurpose paper pick up door. 2. Release two green paper pickup cassette latches and slide the assembly out. 3. Open the fuser access door. 4. Release the fuser access door strap (push down and pull out on the top of the latch and slide up). 5. Pivot the fuser door down until the right hand interlock stud lines up with the keyway fuser bracket and remove the access door. 6. Remove the two screws (captive). 7. Remove the oil bottle. 8. Using the two knobs slide the fuser out as far as the slides will allow and lift off of slide. Note: Lift the fuser out slowly and evenly to prevent oil from being spilled. If the fuser is to be changed or moved, the oil must be removed. a. Locate the oil suction kit (a suction tool and oil storage bottle) shipped with the printer. b. Extract the oil from the oil bottle compartment with the suction tool and put it into the oil storage bottle. c. Drain the oil from the fuser oil pan into the oil bottle compartment by pumping the release lever about 50 times. d. Repeat steps b and c three or four times. e. Put the cap on the oil storage bottle and pack separately. Clean and store the suction tool. To reuse the oil in the storage bottle after you move the printer, pour it back into the oil bottle you were using. Install this bottle in its compartment. Repair Information 4-29