Lexmark Optra C Service Manual - Page 152
Drive Gear Solenoid Assembly, Remove the LVPS.
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
5045-001 Drive Gear Solenoid Assembly See Assembly 13. For cover removals, see "Cover Removals" on page 4-8. 1. Remove the top cover. 2. Remove the left side cover and the rear cover. 3. Remove the rear EMC shield. 4. Open the multipurpose paper pickup door. 5. Release the two green cassette latches and slide the tray out as far as possible. 6. Remove the connector cover (see Assembly 8-24) and disconnect the connector. 7. Remove the LVPS. 8. Disconnect the 2 pin connector and the J2014 connector from the mechanical controller PCB. 9. Remove the four mounting screws 10. Remove the drive gear solenoid assembly. Note: When reinstalling this assembly, turn the main drive motor (M2) counterclockwise after installing the 4 solenoid assembly mounting screws, this ensures that all 4 solenoid have latched up their corresponding gears. Turn M2 until all 4 gears are latched up. 4-26