Lexmark Optra C Service Manual - Page 233
Lubrication Specifications, Lubricants and Cleaners, Preventive Maintenance 6-2
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
5045-001 Lubrication Specifications Use Grease (part 1321875) as needed. Do not over grease the parts, but make sure new parts have adequate lubrication. Use of a spray contact cleaner in most instances will allow normal functioning of the fuser sensors which have been contaminated with silicone oil. The only cleaner currently approved by Lexmark is CRC brand industrial contact cleaner # 03130. In addition to the cautions on the Material Safety Data Sheet (MSDS) label attached to the can, observe the following guidelines: • When spraying either fuser sensor (PS9 or PS10), place a piece of absorbent material below the sensor to catch the excess spray. • Use the supplied nozzle and direct the spray into the small apertures in the inside walls of the sensors. • Spray quickly (approximately 1 second applications). This spray leaves no residue, contains no CFCs and is plastic safe. Do Not use a substitute spray that has not been tested and is not plastic safe. Lubricants and Cleaners Alcohol or Isopropyl MEK Clean: Plastic, rubber and external parts. Clean: Oil and toner stains. Follow manufactures directions. Follow manufacturer's directions. Lubricating Oil Lubricating Grease Spray Cleaner Apply between gear and shaft. Apply to gear. Clean fuser sensors #10 oil #23 grease CRC # 31030 Preventive Maintenance 6-2