Lexmark Optra C Service Manual - Page 149
Density Adjustment Panel, Density Sensor, Repair Information 4-23
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
5045-001 Density Adjustment Panel See Assembly 8-27. For cover removals, see "Cover Removals" on page 4-8. 1. Remove the top cover. 2. Remove the left side cover and the rear cover. 3. Disconnect the wire cable from the density adjustment panel. 4. Remove the screw that retains the fan grill and panel bezel and remove the bezel. 5. Remove the two panel mounting screws and remove the panel. Density Sensor See Assembly 30-6. 1. Open the top cover and disconnect the link. 2. Position the sensor so it is facing up and disconnect the springs at the top end. 3. Lower the sensor to unlock the cable connector at the sensor end and disconnect the ribbon cable. 4. Remove the E-clip and slide the sensor assembly forward to remove it from the machine. Repair Information 4-23