Lexmark Optra C Service Manual - Page 164

5045-001 Note: Steps 12 through 14 may be skipped if an off-set screwdriver is used to remove the screws behind the oil bottle case. 12. Use the hypodermic syringe tool (11A2440) to withdraw the oil from the bottle case. Also remove the square cap from the oil tray and withdraw the oil from the oil tray. Store the oil withdrawn in the oil storage bottle tool (11A2441). 13. Pinch or stop up the tube between the oil bottle case and the oil tray to prevent oil from leaking out. 14. Place the fuser assembly on a shop towel or paper to catch any spilled oil. 15. Remove the four screws from the oil bottle case and remove the case. 16. Remove the screws from lamp wires. 17. Using a small screwdriver or a paper clip, remove the white lamp wires from the terminal block. The wire terminal locking clip is on the inside part of the wire terminal. 18. Remove the two screws from the lamp holder located at the rear of the fuser and remove the holder. 19. Slide the lamps out the back of the fuser assembly. Note: Do not touch the lamps. Body oils can cause the lamp life to degrade. 4-38