Lexmark Optra C Service Manual - Page 188
Toner Cartridge Ejector, See Assembly 12-1.
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
5045-001 Toner Cartridge Ejector See Assembly 12-1. For cover removals, see "Cover Removals" on page 4-8. 1. Remove the two screws from the operator panel and remove the operator panel. 2. Remove the front door. 3. Remove the top cover. 4. Remove the left cover. 5. Remove one of the toner cartridges. 6. Remove the screw and the upper right hand front panel. 7. Remove the four screws and the left front panel. 8. At the left, rear of the ejector assembly there is a latch which goes into the bottom frame. Push this latch toward the center of the machine to release it. 9. Push the ejector to the rear and lift up. 10. Disconnect the connector (either at the ejector board or on the rear frame of the machine). 11. Slide the ejector out of the front of the machine. Do not damage the switch on the ejection sensing PCB located directly below the front of the ejector. Note: When reinstalling, line the handle up with the handle guide before pressing the latches in place. 4-62