Lexmark Optra C Service Manual - Page 73
Fuser/Delivery Unit, Diagnostic Information 2-41, Code 25, Paper Jam
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
5045-001 Fuser/Delivery Unit (Code 25, Paper Jam) Note: Printers and replacement FRUs may experience rough handling during shipping, causing the exit sensor (PS9) to be contaminated with oil. As this sensor operates "active low", the oil may defuse the IR beam enough to prevent correct operation. Therefore, replace PS9. Use of a spray contact cleaner in most instances will allow normal functioning of the fuser sensors, which have been contaminated with silicone oil. The only cleaner currently approved by Lexmark is CRC brand industrial contact cleaner # 03130. In addition to the cautions on the Material Safety Data Sheet (MSDS) label attached to the can, observe the following guidelines: • When spraying either fuser sensor (PS9 or PS10), place a piece of absorbent material below the sensor to catch the excess spray. • Use the supplied nozzle and direct the spray into the small apertures in the inside walls of the sensors. • Spray quickly (approximately 1 second applications). This spray leaves no residue, contains no CFCs and is plastic safe. Do Not use a substitute spray that has not been tested and is not plastic safe. Diagnostic Information 2-41