Lexmark Optra C Service Manual - Page 161

5045-001 Fuser Thermistor See Assembly 32-15. 1. Remove the fuser assembly. 2. Place the fuser on a flat surface. Note: Do not tilt the fuser. It contains oil that can spill. 3. Remove the two screws from the protective cover and remove the cover. 4. Remove the screw from the rear knob and remove the knob. 5. Remove the screw from the shield surrounding the knob and remove the shield. 6. Remove the two screws from the delivery guide located at the top right of the fuser and remove the guide. 7. Remove the two screws from the heater/terminal block cover located at the rear of the fuser and remove the cover. 8. Remove the two screws from the terminal block bracket. 9. Take the fuser lamp cables out of the cable holder located at the top right of the fuse. 10. Remove the four screws from the top of the fuser cleaner assembly (two on each side). 11. Remove the two screws from the front and one screw from the rear of the fuser cleaner assembly and remove the assembly. Repair Information 4-35