Lexmark Optra C Service Manual - Page 187
Transfer Drum Cleaning Drive Assembly, Repair Information 4-61
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
5045-001 Transfer Drum Cleaning Drive Assembly See Assembly 17-1. For cover removals, see "Cover Removals" on page 4-8. 1. Remove the top cover. 2. Remove the left side cover and the rear cover. 3. Remove the EMC shield from the rear of the machine. 4. Open the multipurpose paper pickup door. 5. Release the two green cassette latches and slide the tray out as far as possible. 6. Remove the connector cover (Asm 8-24) and disconnect the connector. 7. Remove the LVPS. 8. Disconnect connector (J2014) from the mechanical controller PCB. 9. Remove the four mounting screws from the drive gear solenoid assembly and remove the assembly. Disconnect the remaining 2-pin connector from the frame. 10. Remove the four screws from the main drive motor and board assembly and remove the assembly. 11. Remove the three screws from the transfer drum drive assembly and remove the assembly. Note: One of the screws is accessed through a hole in the printer drive assembly. Repair Information 4-61