Lexmark Optra C Service Manual - Page 38
Oil Bottle Empty/Missing, Paper Feed Mechanism Missing
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
5045-001 Code 41 42 43 44 45 Symptom Waste Bottle Full Check for: • Full bottle • Improper installation • Missing bottle • Broken interlock • Toner on window of bottle (Use a clean, dry rag to clean the window. Do not use finger.) Oil Bottle Empty/Missing Check to ensure the bottle is not empty. If the bottle has oil, remove the fuser and verify the float ball in the oil bottle case is following the level of the oil. Check the operation of the oil sensor PCB in the machine, (it is not in the fuser). Photoconductor Unit Missing Ensure that the photoconductor unit is completely seated in the machine. Check the continuity from J1004-5 on the HVPS to the spring that contacts the pad on the rear of the photoconductor. There is a resistor of approximately ± 9K ohms in this line. Fuser Life Exhausted Remove the fuser from the printer. Remove the yellow cover from the top of the fuser and verify that the cleaning web is exhausted. A notch at the life limit of the web allows an arm to drop, which blocks a sensor located on the printer, (not the fuser) near the exit drive mechanism. If the web is exhausted, drain the fuser oil and replace the fuser. If the arm has prematurely dropped, (or if the customer has pushed it down), reset the arm on top of the web and reinstall the fuser. Note: Fuser replacement is the responsibility of the customer. Paper Feed Mechanism Missing Either the paper feed mechanism has not been securely latched into the machine or there is a problem with the self docking connector. 2-6