Lexmark Optra C Service Manual - Page 177
Transfer Drum and Holder Assembly, Repair Information 4-51
View all Lexmark Optra C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
5045-001 Transfer Drum and Holder Assembly See Assembly 29-1. Note: This procedure removes the transfer drum assembly from the transfer drum holder assembly. 1. Remove the transfer drum and holder assembly. 2. Remove the 4 screws from the two transfer drum holder covers and remove the covers. 3. Remove the screw from the drum knob assembly and remove the knob. 4. Remove the spring and three screws from the separation claw and remove the claw. 5. Remove the two springs from the attraction roller holder. 6. Remove the connector shield from the back of the holder front plate. 7. Disconnect the three connectors in the holder front plate. 8. Remove the two screws from the waste toner cartridge lock bracket located on the transfer drum holder front plate and remove the bracket. 9. Remove the extension spring from the transfer drum holder rear plate. 10. Remove the front and rear levers from the transfer drum holder plates. The rear lever is mounted to a stud in the plate. The front lever is mounted with a pin. Remove the screw from the pin and remove the pin. 11. Remove the two screws from the pin located at the bottom right corner of the transfer drum holder front plate and remove the pin. 12. Lift the transfer drum assembly out of the transfer drum holder assembly. Repair Information 4-51