Netgear FVS318 FVS318v3 Reference Manual - Page 84
Start, ping -t 192.168.3.1, Ctrl-C, Gateway-to-Gateway Configuration
UPC - 606449023381
View all Netgear FVS318 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Reference Manual for the ProSafe VPN Firewall FVS318v3 a. Establish an Internet connection from the PC. b. On the Windows taskbar, click the Start button, and then click Run. c. Type ping -t 192.168.3.1 and then click OK. Figure 5-34: Running a Ping test to the LAN from the PC This will cause a continuous ping to be sent to the first FVS318v3. Within two minutes, the ping response should change from "timed out" to "reply." Note: Use Ctrl-C to stop the pinging. Figure 5-35: Ping test results Once the connection is established, you can open the browser of the PC and enter the LAN IP address of the remote FVS318v3. After a short wait, you should see the login screen of the VPN Firewall (unless another PC already has the FVS318v3 management interface open). • Gateway-to-Gateway Configuration-test the VPN tunnel by pinging the remote network from a PC attached to the FVS318v3. a. Open a command prompt (Start -> Run -> cmd). b. Type ping 192.168.3.1. 5-28 January 2005 Basic Virtual Private Networking