Nokia IP1220 Installation Guide - Page 107
Installing a Fan Unit, Before You Begin, To replace a fan unit
View all Nokia IP1220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Installing a Fan Unit The PKCS#11 token that enables IKE acceleration is registered with the Check Point software on your appliance. After you register the module, you must install the Check Point security policy on the firewall for the Nokia encryption accelerator card to perform IKE acceleration. Installing a Fan Unit The fan unit is hot swappable. You can remove and install the fan unit on the back of the IP1200 Series without shutting the appliance down. Before You Begin To replace a fan unit, you need: Physical access to the IP1200 Series appliance. Replacement fan unit kit and appropriate documentation. Caution Components inside the appliance can overheat if they are not cooled even for a short period of time. If you are replacing a failed fan unit, and do not completely remove power to the appliance, do not allow the appliance to run without a fan unit for any longer than necessary. To replace a fan unit 1. Locate the fan unit on the back of the IP1200 Series appliance and the four retaining screws that secure it. Fan unit 00308a 2. Loosen the retaining screws by turning them counterclockwise. IP1220 and IP1260 Security Platforms Installation Guide 107