Nokia IP1220 Installation Guide - Page 70
Release the transceiver by rotating the latch lever., Pull out the transceiver.
View all Nokia IP1220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
6 About IP1200 Appliance ADP Services Modules Type Short-range Long range Latch lever color Beige Blue Latch lever 1 1 2 2 3 3 4 4 Flip latch lever down before inserting the ADP transceiver 00652 To install an ADP transceiver: Push the transceiver into an available port in the ADP module. Rotate the module latch lever down to secure the transceiver in the ADP module. Note Depending on the design of your transceiver, you might need to rotate the latch lever upward to release the device. Insert an appropriate interface cable into the transceiver. To remove an ADP transceiver: Remove the cable. Release the transceiver by rotating the latch lever. Pull out the transceiver. Note that if you install any ADP transceivers that are not supported by Nokia, they are not recognized by Nokia IPSO; the system rejects the transceivers and includes them in a list of 70 IP1220 and IP1260 Security Platforms Installation Guide