Nokia IP1220 Installation Guide - Page 68
Installing and Replacing ADP Modules
View all Nokia IP1220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
6 About IP1200 Appliance ADP Services Modules Installing and Replacing ADP Modules Note Before you begin this procedure, you should review all ADP module information in the Nokia Getting Started Guide and Release Notes for the version of Nokia IPSO you are using and refer to both of these documents as needed as you complete the installation and configuration process. Use these instructions to install an ADP module in your appliance. Before You Begin To install a Nokia ADP module, you need the following: A Phillips-head screwdriver Physical access to the appliance Access to the appliance by using Nokia Network Voyager or the CLI A suitable, grounded work surface The ADP module kit To install an ADP module in IP1220 and IP1260 appliances Use the procedures included in the Nokia IP1200 Series Security Platform Installation Guide or the Nokia IP1220 and IP1260 Security Platforms Installation Guide to install or replace Nokia ADP module in your appliance. There are few differences between the procedures for installing and replacing IP1200 PMC NIC card carriers and the ADP module other than the following steps and considerations: Before you remove your PMC NIC card carriers and replace them with your ADP module, do the following: You cannot preserve the configuration for slots 1 and 2 of your appliance when you replace your PMC NIC card carriers with an ADP module or, conversely, when you replace your ADP module with PMC NIC card carriers due to interface naming convention differences. Therefore, you need to delete all existing configurations associated with slots 1 and 2. Upgrade the Nokia IPSO software to the required version as described in the Nokia Getting Started Guide and Release Notes that you received with your ADP module. You need to have both slots free to install the ADP module, as the module occupies both slots. That is, you must first remove any installed PMC card carriers. For the card carrier removal procedure, see the IP1200 Series Security Platform Installation Guide or the Nokia IP1220 and IP1260 Security Platforms Installation Guide. Note You must first power down your IP1220 or IP1260 appliance before you remove any installed card carriers. 68 IP1220 and IP1260 Security Platforms Installation Guide