Polaroid LDTV152 Owners Guide - Page 56

56

6.

NetCommand IR Control

To perform this procedure, you need:

The remote controls for both the TV and the

•

device you want to control.

The IR emitter cable supplied with the TV.

•

Note:

To set up an A/V receiver, see

“Setting Up

NetCommand Control of an A/V Receiver,” page

60.

Connect and position the IR emitters for the

1.

devices you wish to control.

See

“IR Emitter Place-

ment” on

the previous page.

Set the

2.

TV’s

remote control slide switch to the

TV

position and power on the TV if needed.

Open the NetCommand

3.

Learn

screen in one of two

ways:

If working from the

•

Auto Input Sensing

screen

for the device, highlight the

Learn

icon and

press

ENTER

to open the

Learn

screen for the

device.

If performing NetCommand setup at any time

•

after the device has been recognized through

Auto Input Sensing:

a.

Press

INPUT

to open the

Input Selection

menu.

b.

Highlight the desired input icon and press

ENTER

to switch to that input.

c.

Press

MENU

, highlight

Inputs

, and highlight

Learn

to open the

Inputs > Learn

screen

for the device.

The first function highlighted in the

4.

Learn

screen

is always

Power On

.

Aim the

TV’s

remote control

at the TV and press

ENTER

to begin learning for that

function.

When the

5.

Power On

text starts flashing, aim the

device’s

remote control at the TV and press and

hold the

POWER

key until a check mark appears next

to

Power On

.

If the text stops flashing before the check mark

•

appears, repeat the previous step.

To remove the key from NetCommand control,

•

press the

CANCEL

key while the key name is

highlighted.

Press the

6.

keys on the

TV’s

remote control

to highlight other keys on the list.

Repeat steps

4 and 5 for each additional function you wish to

control through NetCommand.

If the device’s remote control has keys that are not

7.

in the list, you can associate up to any four keys

with the

F1

through

F4

keys.

Perform NetCommand

setup for the

F

keys the same way you did for the

named keys

.

For example, you can:

Assign your DVD player’s

•

CHAPTER SKIP FORWARD

and

CHAPTER SKIP BACK

keys to

F1

and

F2

.

“Learn” your A/V receiver’s DSP options for the

•

current device.

If the device has a separate

8.

POWER OFF

key, press

on the

TV’s

remote to highlight

Power Off

.

Repeat the earlier steps to “learn” the

POWER OFF

key.

If the device has no

POWER OFF

key, skip this step.

Press

9.

EXIT

to finish NetCommand “learning” for the

current device.

From the Auto Input Sensing screen, highlight the Learn

icon and press ENTER to open the NetCommand Learn

screen.

Inputs > Learn screen

Adding or Removing Device Keys

from NetCommand Control

Press

1.

INPUT

to open the

Input Selection

menu, high-

light the device’s icon and press

ENTER

.

Open the

2.

Inputs

menu and highlight the

Learn

icon.

When the

3.

Learn

screen displays:

To add keys:

Continue as described earlier

•

under

“Initial NetCommand Setup for Most

Devices” on this page.

To delete keys:

Highlight the name of the key

•

you wish to delete and press

CANCEL

on the

TV‘s

remote control to clear the check mark.

Initial NetCommand Setup for Most Devices

Polaroid LDTV152 Owners Guide - Page 56

Adding or Removing Device Keys, from NetCommand Control, Initial NetCommand Setup for Most Devices

Page 56 highlights