Polaroid LDTV152 Owners Guide - Page 89

Appendices 89 Appendix F: Troubleshooting, continued NetCommand IR Control Symptom Remarks 3. The A/V receiver is the selected audio source • Check to see if the A/V Receiver power is turned on. but there is no sound. • A/V Receiver Set Up for Audio-Only Switching - With A/V receiver power turned on, redisplay the Input Selection menu and press ENTER to allow NetCommand to correctly select the A/V Receiver input. - Incorrect setup in the Inputs > AVR menu. Check the device connection assigned in the AV Receiver menu. • A/V Receiver Set Up for Audio and Video Switching over HDMI - If the device is connected only to the TV (e.g., on ANT1, ANT 2, or the convenience jacks), verify that the TV's AUDIO OUTPUT is connected to the A/V receiver. - The A/V receiver is not switching properly because you have not learned the inputs. See "Setting Up NetCommand Control of an A/V Receiver," page 60. 4. There is no sound from the A/V receiver NetCommand A/V receiver setup for the DVD player or digital for my DVD player or other surround sound surround sound device or other device is not switching prop- device even though I learned the IR code for erly. See chapter 6, "NetCommand IR Control," and perform the A/V receiver's DVD input or other input. A/V receiver setup for a digital surround sound device as (A/V Receiver Set Up for Audio-Only Switch- described under "A/V Receiver Control: Automatic Audio ing) Switching," page 61. 5. There is no sound or picture from the A/V receiver for my DVD player or other device connected to the A/V receiver; the A/V receiver should be sending video to the TV over an HDMI cable. (A/V Receiver Set Up for Audio and Video Switching over HDMI) NetCommand A/V receiver setup is not switching audio and video inputs properly. See "Setup to Control Automatic Audio and Video Switching via HDMI," page 64. 6. I've selected my DVD player or other surround sound device in combination with the TV speakers but hear no sound from the TV speakers. • A/V Receiver Set Up for Audio-Only Switching If you have only an audio connection from the device to the A/V receiver, a physical audio connection from the device to the TV is also required. - Connect the left and right audio output from the device to the appropriate TV audio input. Now you can hear audio from the device through either the TV speakers or the A/V receiver. - To switch audio sources, press AUDIO, press to show the Speakers option, then press to select AV Receiver or TV. • A/V Receiver Set Up for Audio and Video Switching over HDMI With your DVD player connected to the A/V receiver, only video is passed from the A/V receiver to the TV because of copy-protection restrictions on the HDMI signal 7. I "learned" the RECORD key for my VCR/DVR Check that the VCR or DVR is receiving a signal directly from but when I pressed the RECORD key, the your cable box or satellite receiver. VCR/DVR did not record anything.