Ricoh InfoPrint Pro C900AFP InfoPrint Manager - Page 364

Restarting the job that was printing when the problem occurred You can either: v Start the job from the beginning. v Start the job from a point before the problem occurred (so the ruined pages get printed). Important: - You can only start printing in the middle of the job if the job is transformed to AFP before it gets printed. You cannot print part of an ASCII, KGL, metacode, or LCDS job; you have to print the whole job. - You can start printing in the middle of the job, even if the job has more than one printable documents. You can do this by specifying a sheet range (or multiple sheet ranges) to be reprinted. 1. To print the entire job on the same printer it was printing on before, select the job in the job window and click Job → Release. The job will start printing from the first page. 2. To print the entire job on a different printer, skip to Before you Continue between steps 8 and 9 below. 3. To print only part of the job, figure out what page you want to start printing from. Important: If you do not want to start printing from the first page of the job, be careful when you choose which page to start with. Duplex and n-up jobs can be confusing because you have to start printing with the first page on the front side of the sheet of paper. If you do not choose the correct start page, the job will print, but the sequence will probably be wrong. The easiest way to avoid this is to choose a sheet range specifying the start and the end of the sheet that you want to print. For example, if you are printing a 2-up duplex job, each sheet of paper actually has four pages printed on it, like this: Table 51. 2-up duplex print job: front and back views Front of sheet Back of sheet Sheet one page 1 page 3 page 4 page 2 Sheet two page 5 page 7 page 8 page 6 346 InfoPrint Manager for Windows: Procedures