Sony BVME251 Operation Guide - Page 14
DC IN 24V - 28V DC power input connector, DC 12V OUT connector female
View all Sony BVME251 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Protection), a copy protection technology that incorporates coding technology for digital video signals. 1) The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries. Note The HDMI audio signal is not available for this monitor. Use HDMI compliant cable (sold separately), Category 2 (High Speed HDMI Cable), with HDMI logo. DC 12V OUT connector (female) Supplies the DC power to the controller. Connect to the DC 12V connector of the controller with the SMF-17R20 or the cable supplied with the BKM37H/38H/39H. PARALLEL REMOTE connector (RJ-45, 8-pin) Forms a parallel switch and controls the monitor externally. CAUTION For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. Follow the instructions for this port. Pin assignment Wiring required to use the Remote Control Connect the function you want to use with a Remote Control to the Ground (Pin 5). LAN (10/100) connector Connect to the LAN (10/100) connector of the controller by using the SMF-17R20 or the cable supplied with the BKM-37H/38H/39H. Or connect to the network or the LAN (10/100) connector of the controller by using a 10BASE-T/100BASE-TX LAN cable (shielded-type, sold separately). CAUTION For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. Follow the instructions for this port. When you connect the LAN cable of the unit to peripheral device, use a shielded-type cable to prevent malfunction due to radiation noise. The connection speed may be affected by the network system. This unit does not guarantee the communication speed or quality of 10BASE-T/ 100BASE-TX. NETWORK switch LAN: When connecting to the network. PEER TO PEER: When connecting to the LAN (10/100) connector of the controller in 1 to 1 connection. DC IN 24V - 28V (DC power input) connector (XLR 4-pin, male) Connect the 24V to 28V DC power supply. Pin number 1 2 3 4 5 6 7 8 Functions Designating input signal channel 1 (numeric keypad function) Designating input signal channel 2 (numeric keypad function) Marker (set in the [Marker Setting] menu) On/Off (MARKER button function) Selecting whether monochrome image is displayed or the monitor switches the display mode automatically between color image and monochrome image depending on the input signal (MONO button function). GND Not connected Not connected Tally lamp On/Off You can assign functions using the [Parallel Remote] menu (page 61) of the [System Configuration] menu. Pin number Functions 1 - (GND) 2 NC 3 NC 4 + (DC 24V - 28V) AC IN connector (3-pin) Connects the monitor to an AC power source, via the supplied AC power cord. Power switch When turned on, the monitor enters operation mode. By setting in the [Power] menu (page 62) of the [System Configuration] menu, the monitor can also be set to enter sleep mode when the power switch is turned on. 14 Location and Function of Parts and Controls