Sony BVME251 Operation Guide - Page 46
[Function Setting] Menu, Marker Setting]
View all Sony BVME251 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
- When [Pixel Zoom] is set to on When the HDMI computer signal is input (The native scan is displayed regardless of the setting.) When a digital cinema signal (2048 × 1080) is input and the internal signal is displayed ([Native Scan] is set to [Off] and the normal scan is displayed regardless of the setting.) When the signal system is the SD signal of 720 × 576, [Native Scan Mode] is set to [Aspect Correction] or [×2] and the internal signal is displayed ([Native Scan] is set to [Off] and the normal scan is displayed regardless of the setting.) Display of the input signal system 2048 × 1080 When the input signal system is 2048 × 1080 and the native scan mode is selected, you can display no display area of the left and right sides over the H size (1920) by sliding the picture with the PHASE knob of the controller. You can restore the display position to the center by pressing the MANUAL button of PHASE on the controller. Displayed by sliding the picture with the PHASE knob of the controller. Note The set position is held even when the system is changed to another input signal system. Display of the input signal system 576/50i or 576/ 50P When the input signal system is the SD signal of 720 × 576 and [Native Scan Mode] is set to [×2] or [Aspect Correction], you can display no display area of the upper and lower sides over the V size (1080) by sliding the picture with the UP/DOWN button of the controller. And when the input signal is the same as above and [Native Scan Mode] is set to [Aspect Correction] and the aspect ratio is 16:9, you can display no display area of the left and right sides over the H size (1920) by sliding the picture with the PHASE knob of the controller. You can restore the display position to the center by pressing the MANUAL button of PHASE on the controller. Displayed the whole picture of the H direction by sliding the picture with the PHASE knob of the controller. UP button DOWN button Displayed the whole picture of the V direction by sliding the picture with the UP/DOWN button of the controller. DOWN button UP button Note The set position is held even when the system is changed to another input signal system. [Function Setting] Menu This menu is used to set the function related to the picture display. When [Function Setting] is selected, the following menu is displayed. [Marker Setting] Sets whether or not to display the marker when the MARKER button is pressed. Also sets the display mode. When the item is selected, the marker preset data to be set is displayed. To change the marker preset data to be adjusted, you can select from [Marker1], [Marker2], [Marker3], [Marker4], and [Marker5] in the [Marker Preset] menu (page 37) of the [Channel Configuration] menu. 46 Adjustment Using the Menus