Sony BVME251 Operation Guide - Page 19
Connecting the Power Cord, To connect the AC power cord, Turning on the Monitor
View all Sony BVME251 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Connecting the Power Cord Turning on the Monitor Press the power switch on the rear panel to turn on the power. You can operate the monitor with AC or DC power supply. To connect the AC power cord 1 Plug the AC power cord into the AC IN connector on the rear panel then attach the AC plug holder (supplied) to the AC power cord. AC power cord (supplied) AC IN connector AC plug holder (supplied) 2 Slide the AC plug holder over the cord until it locks. When you turn on the monitor for the first time after purchasing it, the [Select Area] screen is displayed. Select the area where you intend to use this monitor. For selecting the area, see page 20. The warm-up time is more than 30 minutes, approximately. When the monitor is in sleep mode As the OPERATE indicator lights in red in sleep mode, press the MONITOR switch of the controller. The OPERATE indicator lights in green and the monitor enters operation mode. To remove the AC power cord Pull out the AC plug holder while pressing the lock levers. To connect the DC power supply Connect the DC power supply to the DC IN 24V - 28V connector. When the AC power cord and DC power supply are connected, the AC power supply is given preference over the DC power supply. To use the DC power supply, disconnect the AC power cord. 19 Connecting the Power Cord