Sony BVME251 Operation Guide - Page 16
Attaching the Handle (BVM-E171), Connecting the Controller (BKM-17R
View all Sony BVME251 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Attaching the Handle (BVM-E171) 1 Remove the 2 screws on the top side. Connecting the Controller (BKM-17R) Note When you connect the BKM-16R, refer to the operating instructions of BKM-16R. NETWORK switch: Set to PEER TO PEER. Note Keep the removed screws in a safe place to prevent them from being lost. 2 Attach the handle with the supplied screws. Screws (supplied) Handle (supplied) Notes Make sure that the screw clamp is not loosened. Secure the handle attachment. LAN (10/100) DC 12V OUT connector connector SMF-17R20, etc. Controller (BKM-17R) LAN (10/100) connector DC 12V connector NETWORK switch: Set to PEER TO PEER. 1 Turn off the power switch of the monitor before connecting the units. 2 Set the NETWORK switches of the monitor and the controller to PEER TO PEER. 3 Connect the LAN (10/100) connector of the monitor and the LAN (10/100) connector of the controller by using the SMF-17R20 or the cable supplied with the BKM-37H/38H/39H, or a 10BASE-T/100BASE-TX straight LAN cable (shielded-type, sold separately). 4 Connect the DC 12V OUT connector of the monitor and DC 12V connector of the controller by using the SMF-17R20 or the cable supplied with the 16 Attaching the Handle (BVM-E171) / Connecting the Controller (BKM-17R)