Sony BVME251 Operation Guide - Page 85

Specifications BVM-E251 Picture performance Panel OLED panel Picture size (diagonal) 623.4 mm (24 5/8 inches) Effective picture size (H × V) 543.4 × 305.6 mm (21 1/2 × 12 1/8 inches) Resolution (H × V) 1920 × 1080 pixels (Full HD) Aspect 16:9 Pixel efficiency 99.99% Panel drive RGB 10-bit Panel display frame rate 48 Hz, 50 Hz, 60 Hz 1) See "Picture Frame Display" (page 97). Viewing angle (Panel specification) 89°/89°/89°/89° (typical) (up/down/left/right, contrast > 10:1) Normal scan 0% scan Native scan Mapping the pixels of the signal to the panel to one-to-one mode, or displaying an SD signal of non- square pixels (the number of H pixels of the signal system is 720 or 1440) or a 640 × 480 SD signal of HDMI video by scaling processing of doubling for the V direction and correct aspect ratio for the H direction and also optimizing and displaying a picture by modifying the aperture coefficient value, filter coefficient value, etc. Under scan 3% under scan Over scan Mask of 5% over scan portion in the normal scan Color temperature D55, D61, D65, D93, DCI 2) (Setting possible in other color temperature) Standard luminance (100% white signal input) 100 cd/m2 (Preset1-Preset5) 48 cd/m2 (Preset(DCI)) Color space (color gamut) ITU-R BT.709, EBU, SMPTE-C, DCIP3 3), E251 Native 4), S-GAMUT/SGAMUT3 5), S-GAMUT3.Cine, ITU-R BT.2020 Warm-up time Approx. 30 minutes To provide stable picture quality, turn on the power of the monitor and leave it in this state for more than 30 minutes. 1) 48 Hz and 60 Hz are compatible with a frame rate of 1/ 1.001. 2) DCI: x=0.314 y=0.351 3) Chromaticity points of SMPTE RP 431-2, ITU-R BT.2020, S-Gamut/S-Gamut3, and S-Gamut3.Cine are not covered in full. 4) The BVM-E251 individual chromaticity points. The widest color space setting of the signal reproduced by the BVME251 x y R 0.681 0.319 G 0.189 0.724 B 0.141 0.051 (Typical) 5) For displaying the color space of the wide color space mode which is available for the F65 or PMW-F55/F5 CineAlta 4K Camera, etc. Input SDI BNC (×2) Input impedance: 75 ohms unbalanced Signal format: See "Available Signal Formats" (page 88). Sampling frequency 3G-SDI: Y/Cb/Cr (4:2:2): 148.5 MHz/74.25 MHz/74.25 MHz Y/Cb/Cr (4:4:4): 74.25 MHz/74.25 MHz/74.25 MHz G/B/R (4:4:4): 74.25 MHz/74.25 MHz/74.25 MHz HD-SDI: Y/Cb/Cr (4:2:2): 74.25 MHz/37.125 MHz/37.125 MHz SD-SDI: Y/Cb/Cr (4:2:2): 13.5 MHz/6.75 MHz/6.75 MHz Quantization 3G-SDI: 10bit/sample, 12bit/sample HD-SDI: 10bit/sample SD-SDI: 10bit/sample Composite input (NTSC/PAL/PAL-M) BNC type (×1) 1 Vp-p ±3 dB sync negative HDMI HDMI (×1) HDCP1.4 correspondence, Deep Color correspondence Signal format: See "HDMI" (page 92) of "Available Signal Formats". Parallel remote RJ-45 (×1) Serial remote (LAN) Ethernet (10BASE-T/100BASE-TX) RJ-45 (×1) 85 Specifications