TP-Link T1600G-18TS T1600G-18TSUN V2 CLI Reference Guide Guide - Page 209

21.8 lldp tlv-select Description The lldp tlv-select command is used to configure TLVs to be included in outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command. By default, All TLVs are included in outgoing LLDPDU. Syntax lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ] [ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ] [ vlan-name ] [ link-aggregation ] [ mac-phy-cfg ] [ max-frame-size ] [ power ] [ all ] } no lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ] [ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ] [ vlan-name ] [ link-aggregation ] [ mac-phy-cfg ] [ max-frame-size ] [ power ] [ all ] } Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Exclude "management-address" and "port-vlan-id" TLVs in LLDPDU outgoing from Gigabit Ethernet port 1/0/1: Switch(config)# interface gigabitEthernet 1/0/1 Switch(config-if)# no lldp tlv-select management-address port-vlan 21.9 lldp management-address Description The lldp management-address command is used to configure the port's management address to be included in management address TLV. The NMS uses management addresses to identify the devices. To delete the port's management address, please use no lldp management address command. 188